DS-120 tilt sensor / tilt switch contacts contact number & arrangement spst-no (1 n/o), 1 form a contact material ruthenium max. switching voltage dc 48v rated load w 10w maximum switching current ma 400ma operating angle operate less than -10 (refer to fig.3) release less than +10 (refer to fig. 3) general data housing material abs color black sealing ip65 dimensions inches refer to figs. 1 & 2 lead cable length inches (mm) 2 x 4.25 (108mm) termination skived end type 20awg xlpe (automotive grade) color black weight 0.036 pounds (16.3 grams) ambient temperature storage c -40c ~ +85c operating c -40c ~ +85c shock resistance g 30g for 11ms, half sine. vibration resistance g 3 axis @ 4g. 5-500hz for 3hrs. ? non-mercury tilt switch/sensor. ? switching/sensing of tilt in mechanical linkages. ? suitable for digital logic inputs or leds. ? may be used to operate a relay (with suitable protection). ref: ds120 110413jhm/kv page 1 of 2 www.aecsensors.com sales department tel: (888) 847-6552
DS-120 tilt sensor / tilt switch american electronic components inc., 1101 lafayette st. elkhart, in46516 page 2 of 2 www.aecsensors.com sales department tel: (888) 847-6552 specifcations are subject to change without notice. e&oe. ref: ds120 110413jhm/kv dimensions: DS-120-b (with stand-offs) fig. 2 re f re f 1.07 ?.219 ?.24 r.19 .5 8 .2 5 4.25 1.67 .1 5 .4 9 .7 5 a .6 5 .5 8 .5 8 .11 re f .214 dia. + 0.0/-.005 .0 6 dimensions: DS-120-a (no stand-offs) fig. 1 re f 1.07 ?.219 ?.219 r.19 .5 8 .2 5 1.66 .1 5 .7 5 .5 8 .5 8 4.25 all dimensions in inches mounting & method of operation fig. 3 mounting: on a vertical surface with mounting bracket on low side or alternatively oriented on high side of sensor body. if mounting on a non-magnetic surface, select DS-120-a with the thin screw bracket, but if mounting on steel or other magnetic materials then use 1/2 plastic spacers or select DS-120-b with integral spacers. magnetic steel surfaces and ferrous magnetic parts should not be nearer than 1/2 from the sensor body. care must be taken not locate other permanent magnets where they might affect the operation of the DS-120 sensor switch. notes: 1) do not use with relay coils without back emf protection. 2) do not use to directly switch incandescent indicator lamps. (consult factory) 3) do not use to directly switch high inrush loads, capacitive or motor loads; nor, with wire runs longer than 100ft (consult factory) 10 10 included angl e
|
